Crimps copper fittings without a flame, which matters in wood-frame walls where a soldering torch is a fire risk. Faster and cleaner than sweating every joint.
Shower installation humble TX built to last decades
If your old shower pan is cracked, the valve drips behind the wall, or you want a low-curb walk-in before the holidays, our shower installation humble TX crew handles the whole job.
Serving humble and nearby areas.
How big is the shower job?
Pan and valve
New pan set in mortar plus a new mixing valve behind the wall.
- 1. Trim swap New valve cartridge, head, and handles on the existing shower.
- 2. Pan and valve New pan set in mortar plus a new mixing valve behind the wall.
- 3. Full rebuild Demo, drain work, new pan, valve, and wall substrate planned in writing first.
Drag the needle to compareTouch and drag the needle
- 30Services from one local team
- 15Areas served around humble
- Flood testPan filled and checked overnight
- Camera checkDrain line inspected before the pan goes down
What our shower installation includes
Every shower install we quote covers the plumbing work, the pan, and the labor to get it watertight.
Work order
Shower Installation- Demo and haul-away: We remove the old shower or tub surround, cut out the drain, and haul everything to the curb or dumpster. Floors and doorways get protected before a single tool comes in. No debris left in your driveway.
- New pan and drain: The pan is set level in a mortar bed, and the drain flange is connected with the correct gasket and clamping ring. We flood-test the pan for 24 hours before the walls go up to confirm it holds.
- Valve and supply lines: A new pressure-balance or thermostatic valve goes in, connected with copper pipe or PEX pipe. The limit stop is set so water never exceeds 120 degrees. Old galvanized or brittle CPVC gets replaced while the wall is open.
- Wall surround or substrate: Acrylic surrounds get installed per the manufacturer spec. For tile, we hang cement board or a waterproof foam board, tape and seal the seams, and leave a flat, ready surface for your tile setter.
- Sealing and water test: Every seam gets sealed with the correct caulk or silicone. We run hot and cold for 15 minutes and check all joints for weeping. If anything drips, we fix it before we call the job done.
- Permit and inspection: Where the city or county requires a permit, we pull it and schedule the rough-in and final inspections. You get the signed-off paperwork for your records and for resale.
What the first visit covers
First visit
We measure the alcove, check the drain and valve wall, and note the supply line material before quoting the work.
Showers we install in homes
From a single bathroom swap to a full primary bath rebuild.
Tub to walk-in
Drain relocated, low curb framed, grab bar blocking added.
Pan replacement
Old pan cut out, subfloor checked, new pan set level.
Valve upgrade
Anti-scald valve installed and limit stop set at 120 degrees.
Tile-ready prep
Waterproof substrate hung, seams taped and sealed.
Showers we install for businesses
Locker rooms, gyms, and small rental properties across the Humble area.
Locker room showers
Code-compliant valves and drains for heavy daily use.
Rental units
Fast turnarounds with photos documented for the owner.
Multi-family
Repeatable pan and valve installs across several units.
Shower installation humble TX done start to finish
A shower is plumbing you stand in every day. Set the pan level, seal the drain, and test it before the walls close, and it lasts decades. Skip those steps and you pay for it twice.
Shower installation humble TX is the removal of an existing tub or shower unit and the fitting of a new pan, drain assembly, mixing valve, and wall surround or tile-ready substrate. We cut out the old drain, check the P-trap and subfloor for rot, set the new pan level in a mortar bed, and connect hot and cold lines with copper pipe or PEX pipe. Every joint gets pressure-tested before the walls close up.
Humble homes built in the 1970s through the 1990s often still have original fiberglass surrounds and brass valves that no longer meet current flow or anti-scald standards. When you book shower replacement in humble Texas, we scope the job around what is actually behind the wall, not a catalog photo. If your drain is slow or the pan flexes underfoot, that gets fixed during the install instead of after.
- What it is
- Removing an old shower or tub and fitting a new pan, valve, and walls.
- When it helps
- Cracked pan, dripping valve, low pressure, or a step-over you cannot manage.
- What you get
- A watertight shower that holds temperature and drains clean.
What our shower install day looks like
Most showers take one to three days depending on whether we are setting a prefab pan or building a tile-ready base.
Tools and methods we use
Each method answers a different question. Together they leave very little to guess.
Cuts copper square and sweats the joints that need a traditional connection. We still use it on older Humble homes where the existing lines are copper.
Clears hair and soap scum from the trap before the new pan goes in, and confirms the drain line is clear all the way to the main. No surprises after the install.
Finds hidden leaks behind the valve wall without tearing out more than necessary. We use it when a stain shows up on the ceiling below the bathroom.
Breaks loose old valve bodies and makes the new connections. Press fittings on PEX pipe get the job done in a fraction of the time.
When Humble homeowners call us
A 1980s tub-and-shower combo in a Fall Creek home that the owner wants converted to a walk-in before a parent moves in.
We cut out the tub, relocate the drain to center the new pan, frame a 4-inch curb, and add blocking for grab…
HomesA rental near Deerbrook with a shower pan leaking into the unit below and a tenant who cannot be without a shower for long.
We schedule the work for a Monday, demo and set the new pan the same day, and finish the surround and valve…
BusinessesA Kingwood homeowner with hard water scale on a 12-year-old shower valve and a surround that has gone chalky and dull.
We replace the valve and cartridge, install a new acrylic surround, and recommend a water softener to protect the finish.
HomesA commercial property off Townsen with a locker room shower that fails inspection because the anti-scald valve no longer meets code.
We replace the mixing valves with code-compliant thermostatic units, verify the drain size, and pull the permit.
Businesses
How shower installation runs in Humble
Humble sits on clay-heavy soil that moves with our wet-dry cycles, and that movement shows up in bathroom floors. We see more cracked pans and shifted drains here than in cities on sandier ground.
Downtown Humble
Older housing stock with original cast iron drains and brass valves. We plan for drain replacement on most full installs here.
Atascocita
Two-story homes where a failed pan leaks into the ceiling below fast. We always check the first-floor ceiling before we start demo.
Kingwood
Larger bathrooms with tile showers that need full waterproofing rebuilds. Foam board and sealed seams are standard on these jobs.
- Downtown Humble
- Atascocita
- Kingwood
- Fall Creek
- Greensbrook
From problem to finished result.
Slide to compare the photo with an illustrative inspection view. It is generated from the photo, not a measurement.
PhotoCracked pan in a 1985 Atascocita shower
Before: The original fiberglass pan had a hairline crack near the drain, and water had been seeping into the subfloor for months. The ceiling below showed a 3-foot stain, and the floor flexed when you stepped near the drain.
After: We cut out the pan, replaced 4 square feet of rotted subfloor, and set a new acrylic pan in a mortar bed. A new Moen valve went in at the same time. The ceiling stain stopped spreading within a week.
Tub-to-walk-in conversion in Kingwood
Before: A standard 60-inch tub with a 14-inch step-over wall, used by a homeowner whose mother had moved in and could no longer step over it safely. The drain was centered for a tub, not a shower.
After: We relocated the drain, framed a 4-inch curb, added blocking for two grab bars, and installed a thermostatic valve with a hand-held head. The job took four days and passed inspection on the first visit.
Rental shower leak near Deerbrook
Before: A failed pan gasket was leaking into the unit below, and the tenant had been without a working shower for two days. The landlord needed it fixed fast and documented for the insurance claim.
After: We demoed and set a new pan on day one, finished the surround and valve on day two, and sent photos of every step to the landlord. The tenant was back in the shower by Tuesday night.
Shower problems we fix in Humble
Most shower calls start with one of these four symptoms.
Cracked or flexing shower pan
Water seeps under the pan and into the subfloor, then into the ceiling below.
Valve drips or swings hot and cold
A failing cartridge wastes water and can scald when someone flushes a toilet.
Low water pressure at the shower head
Sediment and scale from hard Humble water clog the cartridge and the head.
Mold and mildew on the caulk line
Recurring black spots mean water is getting behind the surround, not just sitting on it.
Why homeowners upgrade their shower
A new shower is one of the few home projects you use every single day.
No more leaks downstairs
A failed pan or grout line can send water into the ceiling below within weeks.
Low-curb walk-in access
Walk in shower installation humble removes the 14-inch tub wall you have to step over.
Consistent temperature
Old two-handle valves swing hot and cold when someone flushes a toilet.
Easy-clean surfaces
Acrylic surrounds and large-format tile wipe down in under a minute.
What you get in writing
Clear records you can keep and share.
Written scope
Pan, valve, walls, and drain work listed line by line.
Photo record
Images of the open wall, drain, and pan before closing.
Test results
Flood test and pressure check noted on the job sheet.
16 years of Humble shower work
Humble Pinewell Plumbing has been installing showers in Harris County since 2010.
Drain camera view
We read the line from the trap to the main to confirm it is clear and correctly sized.
Valve wall inspection
We check the supply line material and look for corrosion or previous leaks behind the trim.
Subfloor moisture
We probe the floor around the drain for soft spots and dampness before setting the new pan.
Is your humble area covered?
Type your ZIP code or town to check. If yours is not listed, call and ask.
humble ZIP codes
- 77338
- 77396
- 77347
Towns we serve.
Based in humble and covering the places around it. Pick one for local details.
What Humble customers say
We had a 30-year-old fiberglass shower that flexed when you stepped in. The crew tore it out, found soft subfloor near the drain, replaced it, and set a new pan in one day. Valve swap and surround on day two. They tested it in front of me and cleaned up better than they found it.
I wanted a walk-in for my mother, no curb to trip over. They measured, explained the slope and the grab bar blocking, and gave me a written price the same afternoon. Three days later it was done. The tile lines are straight and the drain has never backed up once.
I manage four rentals near Townsen and one had a shower leaking into the unit below. They found the failed pan gasket, replaced the pan and valve, and had the tenant back in the shower by the weekend. Fair price and they sent photos of every step for my records.
Frequently Asked Questions
Short answers for the first few minutes. The team can cover the rest.
Still have a question?
Describe what you are seeing and we will point you to the right next step.
(346) 676-4111Cost depends on the pan type, valve brand, whether the subfloor needs repair, and whether tile is involved.
Humble Pinewell Plumbing has been doing shower installs in Harris County since 2010.
A prefab pan and surround swap takes one to two days. A tiled walk-in with a new pan, valve, and waterproofing takes three to five days because of cure time between coats. We give you a day-by-day schedule before we start so you can plan around the bathroom being out of service.
You can hang a surround, but the drain connection, valve, and supply lines are the parts that fail and cause damage. A bad pan seal can rot a subfloor in one season. If you do the tile and finish work yourself, we can handle the rough plumbing, set the pan, and pressure-test before you close the walls.
Book your shower installation humble TX visit
(346) 676-4111Call Humble Pinewell Plumbing and we will get a measure on the calendar, usually within 48 hours.
Get in touch with us
Call us any time, day or night, and we will get a tech dispatched. For non-emergency work, we schedule same-day and next-day appointments across humble and the surrounding Harris County neighborhoods. You will get a service window and a call before we arrive.